Continuously in pursuit of developing innovative products.
ABOUT US
As a GMP, ISO 9001 and ISO 13485 certified factory, with knowledgeable in-house product development and engineering staffs, we can offer you a turn-key service in design solutions and manufacturing continuing to logistics and distribution management. We are specializing in single and multi-shot plastic injection molds and moldings.
1981
Products Development Department was established, specializing in plastic injection molds manufacturing and trading business.
2000
Reliance Design & Manufacture Corporation, located in Tainan, Taiwan, was established as a manufacturer for plastic related products. Products Development Department merged with Reliance Design & Manufacture Corporation.
2000
started two-shot injection molding to produce two-shot mouthguards for athletes.
2004
started three-shot injection molding to produce three-shot mouthguards for athletes.
2005
expended a new product category, making contact lens case.
2009
registered as an ISO 9001 and ISO 13485 certified.
2012
registered as a GMP certified factory and CE certification as well as 510K FDA approval for contact lens case.
OUR FEATURES
With our techniques and experience,
we offer you the following specialties.
Multi-shot plastic
injection mold supplier
Sporting mouthguard
manufacturer
Professional
mouthguard designer
Medical product
manufacturing
capability
One-step & total
solution service
Quality control system
OUR PRODUCTS
MEDICAL PRODUCT
One of our production capabilities is contact lens box. Product is made in compliance with GMP, FDA and CE standards and requirements. Our team takes the ISO 9001 manufacturing procedures seriously from planning stage to shipping products, applying the PDCA cycle (Plan-Do-Check-Action) to ensure quality is under control and continuous improvement will be achieved.
PLASTIC PRODUCT
Customized Plastic
Injection Molding
Our product development staff will assist you to finalize design details, and then bring it into mass production with the best possible cost to you to meet your market demands.
HARDWARE
& PLASTIC INJECTION
PRODUCTION MOLD
With 35 years of engineering experience and knowledge on exporting plastic injection molds, we have made and shipped over 1,300 units worldwide with molds weights ranging from 50 kilograms to 60 tons a unit. Abide by the applications of CPK & PPK process, we have been supplying quality precision parts, such as stamping parts and powder parts and automotive parts since 1996.
SPORTING
ACCESSORIES
Also included in our manufacturing portfolio are sporting accessories such as hand wrap, plastic electronic whistle, water bottle, mat, etc. Customer’s idea or design of products are welcome.
Products Development
100% satisfied service is waiting for you